Instructions to install SGP Metal Skin. Metal Skin for iPhone 3G is used for example.
		Clean the surface with the clothe included.
		Cut pieces seperately for easier installation. Please be careful when you use knife. Do this procedure under guardian's advise if minor.
		Pieces are seperated
		Slowly peel off the covered vinyl on the front as you hold down the actual metal skin piece.
		Take the adhesive tool with fingers as shown in the picture. Make it stick to your thumb.
		Put adhesve tool on back of the corner of metal skin as it is sticked to your thumb, and place the skin on the device. Adhere skin as taking off the back film as shown in the picture.
		Incase of Removal We recommend you to keep the removal tool for incase of removal. Sneak in the removal tool as shown in the picture. DO NOT USE KNIFE TO REMOVE THE METAL SKIN.
		Hold the removal tool with fingers as removal tool is still stuck under the metal skin.
		Remove the metal skin as you lift up the removal tool as shown in the picture. *We recommend to apply metal skin over LCD protector since this product may cause scratches during the installation or removal if it did not followed as properly.