Steinheil - Optical Enhancement Hard Coated LCD Film
The hard coated LCD Protection film is a high quality film that helps to protect LCD screens from damage. It also features advanced optical enhanced film that improve viewing on LCD screens, and has a good surface hardness.

1. Based on PET medium made in Japan, which has more than 95% of light transmission
2. Clean and non- rainbow reflected surface
3. Specially hard coated, which provides high durability protecting scratches (Hardness over 3H)

	Steinheil is a high grade crystal clear film. It is a protective optical enhancement film based on product made in Japan.		Steinheil has a premium hard - coated surface that has no rainbow marks on the coated surface.
	Steinheil has a good surface hardness : 3H ~ 4H and No interference with touch - screen responsiveness.		Steinheil has a premium silicon adhesive - bubble free application.
	Steinheil is an Anti - UV Rays coating film.

INSTRUCTIONS

*It is important that clean both hands before the procedure
*Film may be useless, if some dust or fingerprint gets on adhesive side of film
*You might see thin white lines on the adhesive side. In this case, it is not scratch or dust and it will disappear after 24 hour of attachment.

	Clean both hands and adjust the location where the film would be on the LCD. Since we make our film little bit smaller than actual LCD size, it is important to arrange the film get to center of LCD before you take off all vinyl out of the hard film.
	Clean the LCD with cleaner and cloth included. If there is a dust left on the LCD, that can be annoying afterward. Apply cleaner on the cloth, Not on LCD.
	Take of 1/3 of back vinyl and begin to apply it on the area you desired of LCD. Take of the rest of back vinyl as you fully attach the film.
	Make the film settle on the LCD using the squeegee included. If there is an air bubble, slightly lift up the area that has bubble and adhere again. Or push the bubble out to the sides with the squeegee.
	After attaching works are done, take off the vinyl on the front side with pulling out the sticker attached on the side. *Be sure to remove front cover vinyl. We use thick vinyl for the front to prevent any damages before the application.
*In Case of Dust Left Underneath Afterward
	*If you see any dust after all works are done, lift up a corner with a tape and remove dust.